Asa file transfer invalid http response

If none of the previous steps works, then you can try to remove the erroneous flash card manually and replace it with another working flash card. Refer to these documents for a detailed step-by-step procedure in order to perform this task:.

Removing and Installing the System CompactFlash. Removing and Installing the User CompactFlash. Note: Before you try to manually replace the card, you are advised to contact the Cisco TAC for further troubleshooting. The device should be under valid Cisco contract in order to open a TAC service request. In this section, a list of widely known error messages related to the flash filesystem corruption are shown.

This error results when the show flash command is executed. It does not show any files in the output but this error message. This is a sample output of the command:. When free memory is low close to 0 , show flash does not indicate any files and recommends to run FSCK operation. In this situation, wait for some time so that some memory becomes available by the running applications. Run the show flash command again and see if some memory is available.

If the previous situation prevails, run the FSCK utility. At times, this error can also result when you try to save the configuration on the device. This error results after an upgrade on the FWSM and can be resolved after you run the format utility. The ASA reboot just after the boot up process is completed and after the software version upgraded to 8. In order to rectify this, remove the original existing memory after 2 GB memory upgrade to 8. In order to resolve this, perform a filesystem check so that the error can be removed.

This command sequence is presented for your reference. It is always recommended that you turn off the Cisco ASA while you insert the flash drive. This disables all the running processes and allows the ASA to recognize the flash from the boot process. Before you use any third party flash devices, you need to verify the compatibility with Cisco and verify if it is approved by Cisco.

Cisco recommends to obtain the flash drives from a Cisco authorized seller so that it can be supported. Find A Community. Cisco Community. Thank you for your support! We're happy to announce that we met our goal for the Community Helping Community campaign! Turn on suggestions. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

Showing results for. Search instead for. Did you mean:. All Community This category This board. Luke Smith. Upgrading firmware of an ASA I have this problem too. All forum topics Previous Topic Next Topic.

Abheesh Kumar. Rising star. In response to Luke Smith. In response to Abheesh Kumar. Try with tftp. Same error when I copy from USB Thank you for your support! We're happy to announce that we met our goal for the Community Helping Community campaign! Turn on suggestions. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Showing results for.

Search instead for. Did you mean:. All Community This category This board. Deepak Chauhan. Is it some Cisco bug or something else? Can some body help.

All forum topics Previous Topic Next Topic. Accepted Solutions. Marvin Rhoads. VIP Community Legend.