Windows 7 system boot log

You should no longer find entries for them in the log file. He's covered a variety of topics for over twenty years and is an avid promoter of open source. For more news about Jack Wallen, visit his website jackwallen Step 1: Fire up msconfig To open the tool, do the following: Click the Super-r aka Windows-R key combination to open the run dialog.

Type msconfig. Click either OK or the Enter key to run the command. You'll receive a prompt to reboot the machine, which you'll need to do to complete the setup. Figure A. Editor's Picks. For each third-party driver that you locate, click the upper or lower filter, and then delete the value data. Search through the whole registry for similar items. Process as an appropriate, and then unload the registry hive. To fix problems that occur after you install Windows updates, check for pending updates by using these steps:.

Highlight the loaded test hive, and then search for the pendingxmlidentifier value. If the Stop error occurs late in the startup process, or if the Stop error is still being generated, you can capture a memory dump. A good memory dump can help determine the root cause of the Stop error. For details, see the following articles:. For more information about page file problems in Windows 10 or Windows Server , see the following:.

Check the functionality that is provided by the driver. If the driver is a third-party boot driver, make sure that you understand what it does. If the driver is not important and has no dependencies, load the system hive, and then disable the driver.

If the Stop error indicates general registry corruption, or if you believe that new drivers or services were installed, follow these steps:. Skip to main content. This browser is no longer supported. Download Microsoft Edge More info. Contents Exit focus mode. Is this page helpful? Please rate your experience Yes No. Any additional feedback? Note This article is intended for use by support agents and IT professionals.

Note Starting in Windows 10, version , Windows no longer automatically backs up the system registry to the RegBack folder. Comparing normal mode and safe mode entries enables you to determine which services run in normal mode only-one of which must be the cause of the startup problem if Windows is able to start in safe mode successfully. The following lines are sample Ntbtlog. Note that not every "Did Not Load Driver" message necessarily indicates an error that would prevent Windows from booting, because many drivers are not required for Windows to start.

To repair problems caused by problematic drivers when you can start safe mode, follow these steps:. For the services that run only in normal mode, disable those services one at a time, trying to restart your computer in normal mode after you disable each service.

Continue to disable services individually until your computer starts in normal mode. To repair problems caused by problematic drivers when the computer does not start in safe mode, follow these steps:. Add a comment. Active Oldest Votes. Windows uses event logs with Event Viewer to log this sort of thing: Event ID indicates system startup Event ID indicates system shutdown You should create a custom view in Event Viewer that will filter those two event IDs with the source being the eventlog.

This is the simplest way. Improve this answer. Peter Mortensen I don't have a clue how to create those views, even after I've read those pages. But, there is an easier way. On the right side there is Filter Current Log This will show up only system shutdown events. Do the same for system startup.

With me, event id 12 is the very first one and event id 13 is the last one. Mike Mike 11 2 2 bronze badges. If it does not exist, create it or change the one-liner to use another existing directory.

ToString " with " TimeGenerated. ToString "s" ". There is a built-in time filter in the one-liner only including start and shutdowns after Change "" to something else if older start and shutdowns are needed.